00..... Symbols used and information in repair instructions: Recycling
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
Observe country-specific waste disposal regulations
General information:
Refers to other instructions: such as e.g.:
Necessary preliminary tasks;
Further instructions: refer to operating instructions for balancing machine.
Replacement:
Carry out programming/encoding.
NOTE:
Many electronic control units must be programmed/coded (e.g. when replaced).
NOTE:
(previous symbol):
- Connect BMW diagnosis system
NOTE:
(symbol for new diagnosis system ISID):
- Connect BMW diagnosis system
IMPORTANT:
Read and comply with notes on protection against damage from electrostatic damage (ESD protection).
NOTE:
Electronic control units and other electronic components - if handled incorrectly - can be damaged or destroyed by electrostatic discharge.
Special tools required:
NOTE:
List of special tools needed in these repair instructions.
WARNING:
Laser beam!
For example:
Laser beam at adjustment unit. Do not look into the beam!
Note on laser class.
IMPORTANT:
Use eye protection for the following operations.
For example:
Fuel can emerge spontaneously at high speed when the fuel delivery line is released!
IMPORTANT:
Use eye protection and ear protection for the following operations.
IMPORTANT:
Use face protection for the following operations.
IMPORTANT:
Use protective gloves for the following operations.
Avoid skin contact.
Avoid skin contact.
IMPORTANT:
Use eye protection and protective gloves for the following operations.
Avoid eye contact and skin contact.
Avoid eye contact and skin contact.
WARNING:
Danger of explosion!