32 31 070 Removing and installing / replacing lower section of steering spindle
IMPORTANT:
If the lower section of the steering spindle is separated from the power steering gear/steering column, this can result in damage to the steering column switch cluster when the steering wheel is turned!
Release clamping screw.
Move steering wheel to straight-ahead position and remove ignition key.
Detach lower steering spindle from steering column and remove with double joint towards bottom.
Installation:
Recut thread.
Replace clamping screw.
Clamping screw must rest in groove of steering column.
Tightening torque: 32 31 1AZ, see 32 31 STEERING COLUMN .
Replacement:
Release clamping screw.
Pull lower section of steering spindle (1) out of double joint with flexible disk.
Installation:
Recut thread.
Replace clamping screw.
Clamping screw must rest in groove of lower steering spindle (1).
Tightening torque: 32 31 13AZ, see 32 31 STEERING COLUMN .
After installation:
- Carry out steering angle sensor adjustment, see 61 31 996 Carry out steering angle sensor adjustment .
- Turn steering wheel in both directions to full lockNOTE: The airbag warning lamp must not light up in the process.
- Check directional stability of vehicle