72 11 100 Removing and installing/replacing rear left or right seat belts

Necessary preliminary tasks:

Unclip automatic reel cover (1).

Installation:

If clips are faulty, replace automatic reel cover (1).

Fig 1: Automatic Reel Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Lift out expansion rivet (2).

Installation:

If necessary, replace expander rivet (2).

Unscrew bolt (3).

Unclip cable (4).

NOTE: If necessary, remove fabric adhesive tape.
Remove cover (5) for automatic belt reel.

Fig 2: Screws, Bolt And Cover For Automatic Belt Reel

Courtesy of BMW OF NORTH AMERICA, INC.

Removing left and right seat belts:

Release screw from automatic reel on left and right.

Tightening torque: 72 11 21AZ, see 72 11 SEAT BELTS .

Remove automatic reels on left and right.

Fig 3: Locating Screw On Automatic Reel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pay attention to coding.

Guide lug of automatic reels must be correctly seated in opening in body.

Release screws (1) on left and right.

Tightening torque: 72 11 1AZ, see 72 11 SEAT BELTS .

Remove reversing clip with seat belt (2) on left and right.

Fig 4: Reversing Clip On Seat Belt

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque: 72 11 1AZ, see 72 11 SEAT BELTS .

Remove lower straps (2) and center upper strap (3).

Fig 5: Lower Straps And Center Upper Strap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Belt buckles of lower straps must point to middle.

Fitting of belt buckle middle (1) or top strap middle (1) must be pushed onto tongue of belt buckle (2).

Fig 6: Top Strap Middle On Belt Buckle

Courtesy of BMW OF NORTH AMERICA, INC.