67 61 007 Removing and Installing/Replacing Drive With Gear (Rear) For Actuating Slide/Tilt Sunroof (Rear)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Remove both panels for rear roof pillar
Remove both rear grab handles

Version with dividing net mounts (1):

Fold back cover (2) for dividing net mount (1).

Release screw (3) and remove dividing net mount (1).

Installation:

Observe position indications on reverse side of dividing net mount (1).

IMPORTANT: Do not kink roof liner under any circumstances!

Pull off muckets of rear lid and rear doors in roof area.

Unclip roof liner (1) in middle area downwards and lower.

Installation:

Holder (2) for roof liner (1) must be replaced.

Disconnect plug connection (1) and if necessary expose cable.

Release screws (2) and remove drive (3).

Tightening torque 51 13 1AZ. SeeTRIM PARTS, COVERS, HANDLE TRIM .

Installation:

Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) exactly in gear teeth (3).

Installation:

Initialize slide/tilt sunroof. See 54 0 ... NOTES ON PANORAMA GLASS ROOF (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) .