22 11 001 Replacing Right Engine Mount (N52K)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Secure engine. Refer to 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N62) in installation position
Remove reinforcement plate. Refer to 31 10 010 REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE
Remove heat shields.
Remove engine support arm. Refer to 22 11 100 Replacing Right Engine Support Arm (N52K) .

Release screws (1) and remove engine mount (2).

Tightening torque 22 11 1AZ. Refer to 22 11 ENGINE SUSPENSION .

Fig 1: Identifying Screws And Engine Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Holes (1) in engine mount must point to middle of vehicle.

Fig 2: Identifying Holes

Courtesy of BMW OF NORTH AMERICA, INC.