Mounting engine on assembly stand (N52K)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW X5, 2010 BMW X3, 2009 BMW X5, 2009 BMW X3, and 2008 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 1 450 ASSEMBLY STAND
- 11 3 370
- 11 4 440
- 11 9 261
- 11 9 265
IMPORTANT:
Aluminum screws/bolts must be replaced each time they are released.
The end faces of aluminum screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
The end faces of aluminum screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Necessary preliminary tasks:
- Remove engine
Bolt engine or engine block with steel bolts (1) and aluminum bolts (2) to special tool 11 4 440 .
To release central bolt, bolt on special tools 11 9 261 and 11 9 265 as well.
Mount engine with special tool 11 3 370 to special tool 00 1 450 .