61 35 714 Removing and installing/replacing control unit for slide/tilt sunroof

WARNING: This page is about a different car, the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with 61 35 ... Notes on ESD protection (Electro Static Discharge) .

Necessary preliminary tasks:

Remove front roofliner trim, see 51 44 ... REMOVING AND INSTALLING FRONT ROOFLINER TRIM
Remove complete ceiling light (front)

NOTE: Secure drive for slide/tilt sunroof (3) against falling out.

Release screws (2).

Lower control unit for slide/tilt sunroof (3).

Unlock and disconnect plug connections (1) and remove control unit for slide/tilt sunroof (3).

Fig 1: Identifying Lower Control Unit For Slide/Tilt Sunroof

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Initialise slide/tilt sunroof.

Replacement:

Carry out programming/coding, see Vehicle programming and coding .

IMPORTANT: There is a risk of permanent battery discharge if programming/coding is not carried out!