12 14 550 Replacing control unit (DME)

CAUTION: Follow instructions for REMOVING AND INSTALLING ELECTRONIC CONTROL UNITS

Read the fault memory

Switch off ignition

Detach sealing strips (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Turn tommy bar through approx 90°.

Remove cover.

Courtesy of BMW OF NORTH AMERICA, INC.

Release lock (1).

Remove air funnel (2) towards top.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws.

Tightening torque, 12 90 4AZ.

Remove cover (1) on control unit box.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert fixtures (1) of cover for control unit box in openings (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connectors (1).

Unlock DME control unit (2) and remove.

For subsequent procedure, follow ionstructions of DIS Tester.

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

NOTE: