51 11 156 Removing and installing/replacing front bumper trim (M Technic aerodynamic kit)
Special tools required:
Necessary preliminary tasks:
- Remove both fog light trims, see 51 11 ... Removing and installing/replacing left or right front fog lamp trim (M Technic aerodynamic kit)
Version with headlight washer system:
- Remove both covers for headlight washer system, see 51 11 ... Removing and installing/replacing cover for headlight washer system on left or right (from 09/2006)
Release screws (1).
Remove air duct (2).
Installation:
Make sure air duct (2) is in correct position.
Release screws (1) on bumper trim (2).
Installation:
For adjustment, refer to Body gap dimensions.
Release screws (1 and 2).
Release screws or rivets (1 to 3) on wheel arch trim (4).
Lever out wheel arch trim (4) at side.
Installation:
Make sure wheel arch trim (4) is in correct position.
Release screw (1) on bumper trim (2).
Lever out bumper trim (1) with special tool 00 9 317 in direction of arrow.
Pull bumper trim (1) forwards a little.
If necessary, disconnect plug connections on ultrasonic sensors and/or front fog lamps.
Remove bumper trim (1) towards front with aid of a 2nd person.
Installation:
Tabs (1) on bumper trim (2) must not be damaged.