34 52 535 Replacing a rear pulse generator
IMPORTANT:
Read and comply with 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary tasks:
- Read and comply with General Information, see 34 00 ... General Information .
- Remove lip.
Open plug housing (1).
Pull plug connection for wheel speed sensor out of fixture and disconnect.
Release cable holder along trailing arm.
Release hexagon socket screw (1). Withdraw wheel speed sensor (2) from bore hole.
Installation:
Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease.
Tightening torque: 34 51 6AZ, see 34 51 SLIP CONTROL SYSTEM (ABS, ASC+T, DSC) .