34 52 525 Replacing one front pulse generator
IMPORTANT:
Read and comply with 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Read and comply with General Information, see 34 00 ... General Information .
Open plug housing (1), pull plug connection (2) out of fixture and disconnect.
Pull cable with rubber grommet out of fixture on spring strut and on body.
Installation:
Ensure proper locking of plug connector and proper seating of rubber grommets.
Release socket head cap screw (1).
Withdraw pulse generator (2) from bore.
Installation:
Tightening torque: 34 51 6AZ, see 34 51 SLIP CONTROL SYSTEM (ABS, ASC+T, DSC) .
Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease.