12 61 280 Removing and installing/replacing oil pressure sensor
Necessary preliminary tasks:
- Switch off ignition
- Unfasten oil filter cap to enable engine oil in filter to flow back into the oil sump.
- Remove INTAKE FILTER HOUSING .
Installation location: at base of oil filter.
Disconnect plug connection (2).
Unscrew and remove oil-pressure switch.
IMPORTANT:
Engine oil may emerge when the oil pressure sensor is removed - have a cleaning cloth to hand.
Catch and dispose of emerging engine oil.
Tightening torque 12 61 1AZ .
Installation:
Screw on oil-filter cover tightly.
Check engine oil level, top up engine oil if necessary.