51 71 080 Removing and installing/replacing heater bulkhead

Necessary preliminary tasks:

Remove microfilter for passenger compartment ventilation, see 64 31 010 REPLACING MICROFILTER FOR INTERIOR VENTILATION

Unclip retainers (1) and feed cable out of cable duct.

Fig 1: Retainers

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove microfilter housing towards front.

Installation:

Seals on microfilter housing must not be damaged or missing.

Fig 2: Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Detach rubber strip (1).

Release locks (2) and pull side trim forwards a little.

Fig 3: Rubber Strip And Locks

Courtesy of BMW OF NORTH AMERICA, INC.

Remove screws (1) and (2).

Lift out heater bulkhead.

Fig 4: Screws

Courtesy of BMW OF NORTH AMERICA, INC.