51 2. ... Removing Window Cavity Cover Strip With Special Tool 00 9 324 At Front Or Rear
NOTE:
For Special Tool identification, see MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
Special Tools Required:
- 00 9 318
- 00 9 324
Open complete door window glass.
Front door:
Insert special tool 00 9 324 at front (at A-pillar) in window cavity (1) (letters TOP pointing upwards).
Rear door:
Insert special tool 00 9 324 at rear (at C-pillar) in window cavity (2) (letters TOP pointing upwards).
NOTE:
For purposes of clarity, picture shows inner door panel and door window glass removed.
Special tool 00 9 324 must be correctly guided under window cavity cover strip (1).
- 2 Short leg, bottom.
- 3 Long leg, top (TOP).
NOTE:
Start at the front or rear, depending on the model.
IMPORTANT:
Risk of damage! Raise window cavity cover strip (3) no more than 5 mm in each levering operation, otherwise the strip will be bent.
Position special tool 00 9 318 on door trim panel (1).
Slide screwdriver (2) into special tool 00 9 324 and lever window cavity cover strip (3) upwards no more than 5 mm.
Guide special tools 00 9 324 and 00 9 318 towards front/rear and lever out window cavity cover strip (3) in the process.