Control Modes: Lift

The Lift mode is used to prevent control operations when a wheel is changed or during work on the vehicle while it is on a lifting platform.

This mode is recognized when the permitted rebound travel at one or more wheels is exceeded. For the E65/E66 the limit is > 55mm.

A "jack" situation is also recognized when the ride level is stored and the lowering speed drops below the value of 2 mm/s for 3 seconds.

If the vehicle has been raised slightly and the permitted rebound travel has not yet been achieved, the control operation attempts to readjust the ride height. If the vehicle is not lowered, a car jack situation is recognized after a specific period of time and this ride height is stored.

A reset is performed if the vehicle is again 10 mm below this stored ride height.