51 43 251 Removing and installing / replacing trim for rear left or right roof pillar (rear)

WARNING: Version with head AIRBAG:
Follow safety instructions for working on cars with AIRBAG systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head AIRBAG).

Version with head AIRBAG in rear compartment:

If necessary, lever out AIRBAG emblem (1) and release screw underneath.

Fig 1: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque 51 43 1AZ. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .

Release clips (2) and catches (4) from trim (3).

Pull out trim (3) towards inside at top.

Installation:

If necessary, replace defective grommets (1).

Fig 2: Replacing Defective Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainer (1) on trim (2) must not be damaged or missing.

Fig 3: View Of Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1) of panel (3).

Catches (2) on trim (3) must not be damaged.

Fig 4: View Of Clips & Catches

Courtesy of BMW OF NORTH AMERICA, INC.