51 24 149 Replacing valve on hydraulic unit
Necessary preliminary tasks:
- Remove hydraulic unit for rear lid actuation, refer to 51 24 150 REMOVING AND INSTALLING/REPLACING HYDRAULIC UNIT FOR REAR LID ACTUATION (ELECTROHYDRAULIC-FULLY AUTOMATIC)
Release screws (1).
Detach valve (2) from hydraulic unit (3).
Tightening torque 51 24 9AZ. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .
Installation:
Sealing rings (1) on valve (2) must not be damaged.
Installation:
No dirt may enter bore (1) on hydraulic unit (2).
Check fluid level. Refer to 51 24... NOTES ON AUTOMATIC REAR LID ACTUATION (ELECTROHYDRAULIC-FULLY AUTOMATIC) .