51 31 021 Removing and installing / replacing rubber frame for windscreen (top): Notes

Necessary preliminary tasks:

Remove both trim strips on roof frame, refer to 51 13 280 REMOVING AND INSTALLING TRIM STRIP ON ROOF FRAME AT LEFT OR RIGHT

IMPORTANT: Rubber frame (1) features an aluminum section inlay (2).
If necessary, detach adhesive tape (8) between rubber frame (1) and roof outer skin.
Remove the 4 fitted spacer buffers (7).
Carefully wind out rubber frame (1) (windscreen breakage).

Fig 1: View Of Rubber Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Tear-off lip (5) may be stuck to adhesive (4).
When rubber frame (1) is removed, tear-off lip (5) can tear off and remain in vehicle.

(3) Windscreen

(6) Bridge

Installation:

If necessary, remove adhesive residue from roof outer skin.

After installing rubber frame, fit 4 new spacer buffers (1) *:

Fig 2: Identifying Spacer Buffers

Courtesy of BMW OF NORTH AMERICA, INC.

Shape B** in mm, square 12.7 x 10 x 3.8h
150 mm and 450 mm on left/right from centre

* Sourcing reference: BMW Parts Service

** Repair kit for windscreens