51 49 000 Removing and installing or replacing trim for rear lid

Necessary preliminary tasks:

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Version with manual rear lid unlocking:

Detach handle (1) from clip (2).

Disconnect Bowden cable (3) from handle (1).

Installation:

Guide Bowden cable (3) through clip (2) and connect correctly in handle (1).

Fig 1: Detaching Handle From Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release expansion rivets (1) and clip (2).

Remove trim (3).

Fig 2: Identifying Expansion Rivets And Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace damaged clips (1 and 2).