51 71 447 Removing and installing or replacing panel for cover on left or right side member

Necessary preliminary tasks:

Release expansion rivets (1).

Fig 1: Releasing Expansion Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Releasing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip panel (1) at front.

Unclip panel (1) at rear from holders (2) and remove in direction of arrow.

Fig 3: Removing Panel At Rear From Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on holder (2) must not be damaged.

Fig 4: Identifying Catches On Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, detach holders (1) from body and fit on panel (2).

If necessary, replace faulty holders (1).

Fig 5: Detaching Holders From Body And Fit On Panel

Courtesy of BMW OF NORTH AMERICA, INC.