51 23 211 Removing and installing/replacing cable for front engine hood locks (to passenger compartment)

Necessary preliminary tasks: 

• Disconnect cable for hood/bonnet locks
• Remove lower section of microfilter housing
• Remove trim panel for pedal assembly
• Remove footwell side trim panel on A-pillar

Release screws (1).

Remove fixture (2) and feed out Bowden cable (3).

Fig 1: Removing Fixture And Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Feed Bowden cable (1) out of grommet (2).

Carefully feed Bowden cable (1) with grommet (3) out of vehicle interior.

Fig 2: Identifying Bowden Cable With Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Lay Bowden cable (1) without kinks.