51 11 050 Removing and installing / replacing carrier for front bumper trim
Necessary preliminary tasks:
- Remove front bumper trim, refer to 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .
Detach wiring harness (1) from impact absorber (2).
Version with ACC:
If necessary, remove ACC.
Version with headlight washer system:
If necessary, disconnect line (2) on right from washer fluid reservoir coming from T-distributor (1).
IMPORTANT:
Carrier must not be separated from deformation elements.
NOTE:
The operation is described on the left side; proceed in the same way for the right side.
Release screw (1).
If necessary, drill out rivets (3).
Release screws (2).
Remove carrier (4) with deformation element towards front.
Installation:
If necessary, use screws and locking pins (instead of rivets) to secure deformation element.
Tightening torque, refer to 51 11 4AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 645CI .
Replacement:
- Remove impact absorber
- If necessary, replace high-pressure nozzle of headlight washer system.