51 11 ... Installing/replacing license plate (without base)
Initial fitting:
Place drilling hole template (1) on bumper (2).
NOTE:
Hole diameter = 2.5 mm (see template).
Drill holes according to license plate.
Remove template (1).
Secure license plate with screws provided.
Installation:
Tightening torque, refer to 51 11 7AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 645CI .
Fit protective caps.
Repairing thread:
Drill out defective hole in bumper (2) to 9.5 mm diameter.
Insert blind rivet nut (1).
Secure license plate (3) with license plate screw (M5 x 20).
Installation:
Tightening torque, refer to 51 11 8AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 645CI .