51 14 110 Removing and installing/replacing rear model designation

IMPORTANT: The "Instructions for number/letter combination cementing" serve as the basis for these repair instructions and must be followed without fail.

Fitting dimensions (E63, E64):

Fig 1: Identifying Fitting Dimensions Of Rear Model Designations

Courtesy of BMW OF NORTH AMERICA, INC.

Stick on adhesive tape (1) up to top edge "A". Mark measurement "B" from edge of rear lid (2) on adhesive tape (1).

Dimensions:

NOTE: E63, E64 (without M6) A = 50 mm B = 36 mm

M6 A = 45 mm B = 54 mm

NOTE: Measurements C, D, E and F are for information purposes only, as determined by carrier film. 630 i: C = 6 mm, D = 7.0 mm, E = 22 mm, 645 Ci: C = 7.5 mm, D = 11 mm, E = 20 mm, F = 7.5 mm, M6: C = 7.5 mm