51 24 145 Removing and installing/replacing button for rear lid actuation
NOTE:
For Special Tool identification, see MAINTENANCE & GENERAL INFORMATION - SPECIAL TOOLS - 545i (4.4L) E60/N62 .
Special Tools Required:
- 00 9 323
Necessary Preliminary Tasks:
- Remove panel for rear lid. Refer to 51 49 000 REMOVING AND INSTALLING OR REPLACING TRIM FOR REAR LID .
If necessary, disconnect plug connection in rear lid.
Move special tool 00 9 323 under front edge of button (1) and lever out button (1).
Pull button (1) out of rear lid (2).
Pull off clip (1) and remove microswitch (2). Pull off seal (3).
Installation:
Seal (3) must be undamaged and button must be correctly snapped into place.
Perform function check with trunk lid open.