51 16 360 Removing and installing/replacing right glovebox

NOTE: Open glovebox.

Unclip pin (1) from retaining strap (2).

Fig 1: Disconnecting Retaining Strap

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip pin (1) from shock absorber (2).

Fig 2: Removing Pin From Shock Absorber

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Close glovebox (3) and secure against falling out.

Release screws (1) and remove counter-support (2).

Open glovebox (3) and remove.

Fig 3: View Of Counter-Support

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure counter-support (1) is correctly seated on chamfered faces of shaft (2).

If necessary, turn shaft (2) accordingly.

Fig 4: Aligning Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: