12 61 285 Replacing level switch for engine oil (M62, M54, S54, M56)

Necessary preliminary tasks:

Switch off ignition.
Unfasten cover on full-flow oil filter to enable engine oil in filter to flow back into the oil sump.
Drain engine oil.

These operations are described in 00 00... ENGINE OIL SERVICE .

Remove reinforcement plate. See FRONT AXLE CARRIER .

IMPORTANT: The section Removing and installing reinforcement plate contains important installation instructions.

Disconnect plug connection (1).

Unscrew nuts (2).

Remove level switch (3).

Installation:

Clean sealing surface on oil sump and replace seal of level switch.

Fig 1: Removing Level Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Screw on oil-filter cover tightly.

Top up engine oil.