51 21 125 Removing and installing/replacing carrier for left or right outside door handle (with lock cylinder)

Necessary preliminary tasks:

Driver's side only:

NOTE:

Version with Comfort Access/CA:

CA sensor (4) must not be damaged.

Unlock catches (2) on carrier (1).

Press lock cylinder (5) behind door outer skin (3).

Fig 1: Identifying Catches, Carrier, Lock Cylinder And Door Outer Skin

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, disconnect plug on CA module.

Pull carrier (3) towards rear/top until screw (1) of sheet metal slot (2) is free.

Remove carrier (3) for outside door handle.

Fig 2: Removing Carrier For Outside Door Handle

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seals (1) on carrier (3) must not be damaged.

IMPORTANT:

Water drainage channel (2) must not be fouled/clogged.

Fig 3: Identifying Seals, Carrier & Water Drainage Channel

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

The following work step ends here:

Removing and installing carrier for left or right outside door handle with lock cylinder.

Replacement:

Version with Comfort Access/CA: