51 31 242 Replacing rubber frame (bottom) for rear window

Open rear lid.

IMPORTANT:

Rubber frame (1) features an aluminum section inlay (2).

Carefully unwind rubber frame (1) (rear window breakage).

NOTE:

Tear-off lip (5) may be stuck to adhesive (6).

When rubber frame (1) is removed, tear-off lip (5) can tear off and remain in vehicle.

(3) Pinched butyl

(4) Bridge

(7) Rear window

Fig 1: Replacing Rubber Frame (Bottom) For Rear Window

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

There is no tear-off lip (5) in area (A) on left/right.

Replacement of rubber frame without rear window removal:

Detach tear-off lip (3) from rubber frame (1).

If adhesive has managed to get onto bridge (4), this area must be cut out partially.

Replacement of rubber frame with removed or new rear window:

Fit rubber frame (1) with tear-off lip (5).

(2) Aluminum strip

(3) Butyl

Fig 2: Installing Rubber Frame Into Rear Window

Courtesy of BMW OF NORTH AMERICA, INC.