51 71 080 Removing and installing/replacing partition wall for equipment compartment on right

Release screws.

Remove cover (1) from electronics box.

Fig 1: Removing Cover From Electronics Box

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten rubber seal (1).

Pull wiring harness (2) out of partition wall.

Fig 2: Pulling Wiring Harness Out Of Partition Wall

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw connections.

Fig 3: Detaching Refrigerant Line From Partition Wall

Courtesy of BMW OF NORTH AMERICA, INC.

Detach refrigerant line (1) from partition wall.

Lift out partition wall (2).

Installation:

Install lugs (1) of partition wall on rail (2).

Fig 4: Installing Lugs Of Partition Wall On Rail

Courtesy of BMW OF NORTH AMERICA, INC.