11 11 Engine Block, Cylinder Crankcase M54 B22
WARNING: This page is about a different variant/trim than selected.
ENGINE BLOCK CYLINDER CRANKCASE M54 B22 SPECIFICATIONS
| Bore hole diameter(1) | mm | 80.000+0.010 | ||
| 1. Interference (1) (only permitted for aluminum engine block with cast iron liners) | mm | 80.250+0.010 | ||
| Permitted out-of-round of cylinder bore (1) | mm | 0.005 | ||
| Permitted conicity of cylinder bore (1) | mm | 0.010 | ||
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.15 | ||
|
||||