67 61 517 Replacing drive with gear (rear) for actuating slide/tilt sunroof (panoramic glass sunroof)
WARNING: This page is about a different variant/trim than selected.
Necessary Preliminary Tasks:
- Remove rear grab handles. Refer to 51 16 450 REMOVING AND INSTALLING/REPLACING REAR LEFT/RIGHT GRAB HANDLE .
- Remove trim for rear left and right roof pillar (C-pillar). Refer to 51 43 251 REMOVING AND INSTALLING/REPLACING TRIM PANEL FOR LEFT OR RIGHT REAR ROOF PILLAR (C-PILLAR) .
- Remove trim for rear left and right roof pillar (D-pillar). Refer to 51 43 252 REMOVING AND INSTALLING/REPLACING PANEL FOR REAR ROOF PILLAR (D-PILLAR), LEFT OR RIGHT .
- Detach mucket in area of roofliner.
Unclip covers (1) in direction of arrow and remove. Release screws (2).
IMPORTANT:
Do not under any circumstance kink roofliner (3).
Unclip roofliner (3) at retaining points (4) towards bottom and lower.
NOTE:
Secure drive with gear for actuating slide/tilt sunroof (3) against falling out.
Release screws (2), tightening torque, (2.8 N.m.).
Lower drive with gear for actuating slide/tilt sunroof (3).
NOTE:
Screws (2) are microencapsulated.
Unlock plug connection (1), disconnect and remove drive with gear for actuating slide/tilt sunroof (3).
Installation:
Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) exactly in gear teeth (3).
Installation:
Initialize slide/tilt sunroof. Refer to 54 0 ... NOTES ON STEEL AND GLASS SLIDE/TILT SUNROOFS (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) .