LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2003 >> X5 46i >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (HEATING AND AIR CONDITIONING - REPAIR - X5 (3.0i)) >> Heater With Operation >> 64 11 932 Replacing evaporator temperature sensor (A/C control)

64 11 932 Replacing evaporator temperature sensor (A/C control)

WARNING: This page is about a different variant/trim than selected.

Remove right glovebox. Refer to 51 16 360 REMOVING AND INSTALLING RIGHT GLOVE BOX .

E39, E53: 

Unclip air duct for right footwell (1) and pull out in direction of arrow.

Fig 1: Identifying Air Duct For Right Footwell
G03256717Courtesy of BMW OF NORTH AMERICA, INC.

Break out repair cover (1) with pointed pliers in direction of arrow.

Disconnect connector (2).

Fig 2: Disconnecting Plug Connector
G03256718Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug of faulty evaporator temperature sensor (1) and pull out in direction of arrow.

NOTE: Secure plug of faulty evaporator temperature sensor with fabric adhesive tape.

Insert new evaporator temperature sensor in opening (2) and lock into place.

Fig 3: Unlocking Plug Of Evaporator Temperature Sensor
G03256719Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Make sure evaporator temperature sensor (1) and cable (2) are correctly seated.

Fig 4: Identifying Evaporator Temperature Sensor And Cable
G03256720Courtesy of BMW OF NORTH AMERICA, INC.