61 31 020 Removing and installing ignition switch

WARNING: This page is about a different variant/trim than selected.

Remove upper section of steering column trim. Refer to STEERING COLUMN TRIM (UPPER SECTION) .

Remove lower section of steering column trim. Refer to STEERING COLUMN TRIM (LOWER SECTION) .

Unlock plug connection (1) and disconnect.

Fig 1: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (1).

Move fixture (2) for wiring harness slightly.

Fig 2: Loosening Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove sealing varnish and release headless setscrews (1).

Detach ignition switch (2) in direction of arrow.

Fig 3: Removing Sealing Varnish And Releasing Headless Setscrews

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Secure headless setscrews with sealing varnish.