54 12 210 Removing and installing complete slide/tilt sunroof (frame)

WARNING: This page is about a different variant/trim than selected.

Remove water drain hoses (1) at front/rear.

Unfasten Omega clips (2).

Fig 1: Locating Omega Clips And Water Drain Hoses

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (1) at front and (2) at left/right.

Fig 2: Identifying Screws At Front And Left/Right

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook left/right clip and lower slide/tilt sunroof frame slightly.

Fig 3: Lowering Slide/Tilt Sunroof Frame

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fold up back of frame until rear clips can be unfastened.

Slide slide/tilt sunroof frame backwards and lift out through right rear door.

Fig 4: Sliding Slide/Tilt Sunroof Frame Backwards

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert slide/tilt sunroof frame in sheet metal slot at front.

Fig 5: Inserting Slide/Tilt Sunroof Frame In Sheet Metal Slot

Courtesy of BMW OF NORTH AMERICA, INC.