54 12 120 Replacing seal for slide/tilt sunroof lid
WARNING: This page is about a different variant/trim than selected.
Observe note on repairing bonded seals on slide/tilt sunroof. Refer to 54 0 ... REPAIR INSTRUCTIONS FOR BONDED SEALS .
Open slide/tilt sunroof completely.
Begin removal at contact edge (mostly rear center):
- Peel off rubber seal.
- Clean bonded area.
Installation:
Also begin at specified point of contact edge for installation:
- Stick on rubber seal in sections.
- Establish seal joint.
- Press on seal.