54 13 105 Removing and installing/replacing rear drip moulding
WARNING: This page is about a different variant/trim than selected.
Necessary Preliminary Tasks:
- Remove complete glass slide/tilt sunroof. Refer to 54 13 080 REMOVING AND INSTALLING COMPLETE GLASS SLIDE/TILT SUNROOF .
- Remove glass slide/tilt sunroof lid at rear. Refer to 54 10 175 REMOVING AND INSTALLING REAR GLASS SLIDE/TILT SUNROOF COVER .
Unlock tab (2) and remove drip moulding (1) towards top.
NOTE:
2 springs are loosely connected to guide for drip moulding.
Installation:
Make sure springs are reinstalled on drip moulding carriers.
Removing Drip Moulding Carrier:
NOTE:
Drip moulding carrier cannot be removed without incurring damage.
Break out tabs with a screwdriver and lever out carrier.
Installation:
Replace drip moulding carrier and hook into place.