11 21 571 Replacing grooved ball bearing in crankshaft (M62 / S62)

WARNING: This page is about a different variant/trim than selected.

(Clutch removed)

Remove grooved ball bearing with special tool 11 2 340 in conjunction with special tool 11 2 016.

Fig 1: Removing Grooved Ball Bearing With Special Tool 11 2 340 In Conjunction With Special Tool 11 2 016

Courtesy of BMW OF NORTH AMERICA, INC.

Install new thrust bearing and drive firmly home with special tool 11 2 350 in conjunction with special tool 00 5 500.

Fig 2: Installing Thrust Bearing With Special Tool 11 2 350 In Conjunction With Special Tool 00 5 500

Courtesy of BMW OF NORTH AMERICA, INC.