51 34 160 Removing and installing/replacing cover (anti-trapping protection) on door window frame (rear door), inside left or right

WARNING: This page is about a different variant/trim than selected.

Carefully lever out clip (1) and lever out trim (2) in rear area. Disconnect plug connection (3).

Fig 1: Levering Out Clip And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully lever out clip (1).

Lift out cover (1) from fixed door window.

Fig 2: Lifting Out Cover From Fixed Door Window

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Do not tear off cover (1) in area (2). Lift out and remove cover (2).

Installation:

If applicable, replace defective clips (1).

Fig 3: Replacing Door Trim Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connection (1) of cover (2) must not be damaged.

Fig 4: Identifying Door Trim Cover Connection

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, replace faulty clip (3).

Clips (4) must not be damaged.

Carry out function check.