51 12 742 Replacing one impact absorber for rear bumper
WARNING: This page is about a different variant/trim than selected.
(Bumper Removed)
If necessary, remove rear bumper. Refer to 51 12 000 REMOVING AND INSTALLING COMPLETE REAR BUMPER .
Remove support on side member, refer to Removing trim for tail panel, top. Refer to 51 46 050 REMOVING AND INSTALLING/REPLACING FINISHER FOR TOP OF REAR APRON .
Release nuts (1) on inside and remove shock absorber.
Installation:
Tightening torque, (24 N.m.).