51 45 180 Removing and installing trim for instrument panel, bottom left

Remove trim for pedal assembly. Refer to 51 45 185 REMOVING AND INSTALLING/REPLACING TRIM FOR PEDAL ASSEMBLY .

Release screws (1).

Disconnect plug connection for OBD socket (2).

Unclip rubber gaiter from steering wheel trim and remove trim (2).

Fig 1: Disconnecting Plug Connection For OBD Socket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Clip rubber gaiter (1) correctly with clips (1) into fixtures (3) in steering wheel trim.

Fig 2: Clipping Rubber Gaiter Correctly With Clips Into Fixtures In Steering

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, replace faulty metal nuts (1).

Rubber gaiter (2) and styrofoam (3) must not be damaged.

Replacement Only: 

Remove OBD socket (4) from trim (5).

Fig 3: Clipping Rubber Gaiter With Clips Into Steering Wheel Trim

Courtesy of BMW OF NORTH AMERICA, INC.