51 11 050 Removing and installing/replacing member (cross-member) for front bumper trim

WARNING: This page is about a different variant/trim than selected.

Necessary Preliminary Tasks:

Remove underride protection. Refer to 51 71 378 REMOVING AND INSTALLING/REPLACING UNDERRIDE PROTECTION .

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Lever lower trim (3) out of guide (1).

Unlock catches (2) and remove trim (3) in direction of arrow.

Fig 1: Removing Trim Out Of Guide

G03255595

Courtesy of BMW OF NORTH AMERICA, INC.

Release cable ties (1).

Disconnect plug connections (2) for fanfare horns.

Fig 2: Disconnecting Plug Connections For Fanfare Horns

G03255596

Courtesy of BMW OF NORTH AMERICA, INC.

Release expander rivet (1) from fan impeller (2).

Fig 3: Releasing Expander Rivet From Fan Impeller

G03255597

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For vertical adjustment, mark position of member (3).

Release screws (1).

Release nuts (2) and remove member (3) towards front.

Fig 4: Locating Nuts And Screws On Member

G03255598

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty metal nuts (1).

Fig 5: Identifying Faulty Metal Nuts

G03255599

Courtesy of BMW OF NORTH AMERICA, INC.

Stud bolts (2) on member (3) must not be damaged.

Installation:

If necessary, replace faulty metal nuts (1) on member (6).

Fig 6: Identifying Components On Cross-Member

G03255600

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release nut (3) and remove fanfare horns (2).

Version Up To 10/03:

Release welding spots (4), remove holder (5) and protect bright metal plate against rusting.