13 63 590 Replacing fuel pump relay
WARNING: This page is about a different variant/trim than selected.
Interrogate fault memory of DME control unit.
Switch off ignition.
Remove right glovebox. Refer to 51 16 360 REMOVING AND INSTALLING RIGHT GLOVE BOX .
Release screws (1).
Remove fuse box (2) towards bottom (do not disconnect electrical connections).
Detach fuel pump relay (1).
After removal of fuel pump relay and during engine starting sequence:
- The fuel pump no longer starts up,
- The engine does not start.
NOTE:
Interrogate fault memory of DME control module. Check stored fault messages. Rectify faults. Then clear fault memory.