12 14 700 Coding control module (DME / DDE)
WARNING: This page is about a different variant/trim than selected.
Switch off ignition.
Connect MoDiC or DIS/GT1 Tester.
Switch on ignition.
Select "Coding" program.
For subsequent procedure, follow instructions in MoDiC or DIS/GT1 Tester.
Carry out adjustment of following control units:
- EWS (electronic immobilizer).
- DME (Digital Motor Electronics) or,
- DDE (Digital Diesel Electronics).
Refer to DIAGNOSIS AND CODING service information bulletins on subject of coding.