11 12 503 Disassembling and assembling cylinder head (M52 / S52 / M52TU / M54 / M56)

WARNING: This page is about a different variant/trim than selected.

NOTE:

For Special Tool identification, see SPECIAL TOOLS - X5 (3.0i) .

Special Tools Required:

(Cylinder head removed.)

If necessary, remove coolant thermostat.

Screw on special tool 11 1 442 .

Fig 1: Installing Special Tool 11 1 442

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 11 1 065 onto special tool 00 1 490 .

Provide special tools for disassembling cylinder head:

Special tool 11 1 071 .
Special tool 11 1 067 .
Special tool 11 0 192 .

Fig 2: View Of Engine Hoist
Courtesy of BMW OF NORTH AMERICA, INC.
Special tool 11 1 045
Special tool 11 0 342
Special tool 11 0 343
Special tool 11 0 345
Special tool 11 1 441 .
Assemble special tools.

Fig 3: Identifying Special Tools 11 0 340 Accessories
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Do not install special tool 11 1 441 (locating board) in special tool 11 1 065 at this stage.

Fig 4: Identifying Locating Board

Courtesy of BMW OF NORTH AMERICA, INC.

Place cylinder head on special tool 11 1 065 and screw on with two screws.

Fig 5: Placing Cylinder Head On Locating Board

Courtesy of BMW OF NORTH AMERICA, INC.