67 61 517 Replacing drive with gear (rear) for actuating slide/tilt sunroof (panoramic glass sunroof)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove rear grab handles, refer to 51 16 450 REMOVING AND INSTALLING/REPLACING REAR LEFT/RIGHT GRAB HANDLE
- Remove trim for rear left and right roof pillar (C-pillar), refer to 51 43 251 REMOVING AND INSTALLING/REPLACING TRIM PANEL FOR LEFT OR RIGHT REAR ROOF PILLAR (C PILLAR)
- Remove trim for rear left and right roof pillar (D-pillar), refer to 51 43 252 REMOVING AND INSTALLING/REPLACING PANEL FOR REAR ROOF PILLAR (D-PILLAR), LEFT OR RIGHT
- Detach mucket in area of roofliner
Unclip covers (1) in direction of arrow and remove.
Release screws (2).
IMPORTANT:
Do not under any circumstance kink roofliner (3).
Unclip roofliner (3) at retaining points (4) towards bottom and lower.
NOTE:
Secure drive with gear for actuating slide/tilt sunroof (3) against falling out.
Release screws (2), tightening torque 54 13 1AZ. Refer to SLIDE/TILT ROOF AND CONVERTIBLE TOP - TIGHTENING TORQUES .
Lower drive with gear for actuating slide/tilt sunroof (3).
NOTE:
Screws (2) are microencapsulated.
Unlock plug connection (1), disconnect and remove drive with gear for actuating slide/tilt sunroof (3).
Installation:
Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) exactly in gear teeth (3).
Installation:
- Initialize slide/tilt sunroof. Refer to 54 0 ... NOTES ON STEEL AND GLASS SLIDE/TILT SUNROOFS (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) .