67 61 515 Replacing drive with gear (front) for actuating slide/tilt sunroof
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove bracket from roofliner at front, refer to 51 44 020 REMOVING AND INSTALLING/REPLACING BRACKET ON ROOF LINING AT FRONT
NOTE:
Secure drive (3) against falling out.
Release screws (1) and (2), tightening torque 54 13 1AZ. Refer to SLIDE/TILT ROOF AND CONVERTIBLE TOP - TIGHTENING TORQUES .
Lower drive with gear for actuating slide/tilt sunroof (3).
NOTE:
Screws (1) and (2) are microencapsulated.
Unlock associated plug connection, disconnect and remove drive with gear for actuating slide/tilt sunroof (3).
Installation:
Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) in gear teeth.
Installation:
- Initialize slide/tilt sunroof, refer to 54 0 ... NOTES ON STEEL AND GLASS SLIDE/TILT SUNROOFS (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE)