11 21 Crankshaft and Bearings
WARNING: This page is about a different variant/trim than selected.
CRANKSHAFT AND BEARINGS TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Increment wheel on crankshaft | S54 | M5 10.9 | Replace screws | |
| Jointing torque | 5.0 N.m. | |||
| Torque angle | 45 ° | |||
| Increment wheel on crankshaft | All others | M5 10.9 | Replace screws | 13 N.m. |
| Increment wheel on crankshaft | All others | M5 8.8 | Replace screws | 5.5 N.m. |