LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2003 >> X5 30i, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Pedals - Repair - X5 (4.6L)) >> Pedal mounting block >> 35 11 000 Removing and installing mounting block for pedals

35 11 000 Removing and installing mounting block for pedals

WARNING: This page is about a different variant/trim than selected.

Remove trim for instrument panel at bottom left. Refer to 51 45 180 REMOVING AND INSTALLING TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT .

Remove trim for pedals. Refer to 51 45 185 REMOVING AND INSTALLING/REPLACING TRIM FOR PEDALS .

Release screws (1).

Fig 1: Removing Pedals Mounting Block Screws
G03255528Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and press clips (2) out of light switch.

Fig 2: Removing Light Switch Clips
G03255529Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove reinforcement plate.

Fig 3: Removing Reinforcement Plate
G03255530Courtesy of BMW OF NORTH AMERICA, INC.

Vehicles with manual transmissions: Remove clutch switch.

Remove retainer (1) and press out retaining pin.

CAUTION: Do not detach pressure line from master cylinder.

Release screws (2) and set clutch master cylinder down in footwell.

Fig 4: Removing Clutch Master Cylinder
G03255531Courtesy of BMW OF NORTH AMERICA, INC.

Raise lug of retainer (1) and detach retainer. Pull out retaining pin.

Disconnect plug from brake light switch.

CAUTION: After installation: Adjust brake light switch. Refer to 61 31 310 REPLACING BRAKE LIGHT SWITCH .

Release screws (2) and remove mounting block.

Fig 5: Removing Mounting Block And Retainer
G03255532Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replace self-locking nuts.

Tightening torque, refer to 35 11 1AZ in PEDALS - REPAIR INSTRUCTIONS - X5 .

scientia non olet · About LEMON Manuals