35 21 000 Removing and installing/replacing brake pedal

Remove trim for instrument panel at bottom left. Refer to 51 45 180 REMOVING AND INSTALLING TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT .

Remove trim for pedals. Refer to 51 45 185 REMOVING AND INSTALLING/REPLACING TRIM FOR PEDALS .

If necessary, remove reinforcement plate and switch unit.

Raise lugs on retainers (1) and detach retainers. Unhook spring (2).

Fig 1: Removing Brake Pedal Retainer And Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out retaining pin (1) and detach piston rod from brake pedal.

Remove brake pedal (2).

Fig 2: Removing Piston Rod And Brake Pedal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Check bearing bushes (1) and replace if necessary.

Fig 3: Identifying Bearing Bushes

Courtesy of BMW OF NORTH AMERICA, INC.

Apply a light coat of grease to bearing bushes (1) and bore, refer to BMW SERVICE OPERATING FLUIDS .